Difference between revisions of "LED RGB"
(→Introduction) |
(→Introduction) |
||
| Line 6: | Line 6: | ||
The sensor comes with a JST PA 4P horizontal sticker and a buckle socket. Also, a JST PA SMT 4-Pin to DuPont female single-head wire is offered to facilitate wiring. Length: 210mm, buckle attached. | The sensor comes with a JST PA 4P horizontal sticker and a buckle socket. Also, a JST PA SMT 4-Pin to DuPont female single-head wire is offered to facilitate wiring. Length: 210mm, buckle attached. | ||
---- | ---- | ||
| + | =='''Product Size'''== | ||
| + | {|- | ||
| + | |[[File:LED RGB-3.jpg |left|400px]] | ||
| + | |[[File:LED RGB-4.jpg |left|400px]] | ||
| + | |} | ||
| + | ---- | ||
| + | |||
=='''Connection Diagram'''== | =='''Connection Diagram'''== | ||
{|- | {|- | ||
Revision as of 07:31, 29 July 2020
Introduction
This is a common LED RGB module, in which F5 fog full-color RGB common cathode LED are used as the components. When using it, connect the RGB module to the PWM port of the microcontroller, and connect “-” to GND.
There are red, green and blue lights in the LED components. The principle is that the ratio of the three colors can be adjusted through PWM values, so that different colors of light can be displayed on the LED. In theory, all colors of light can be simulated by adjusting the ratio of the three colors.
The sensor comes with a JST PA 4P horizontal sticker and a buckle socket. Also, a JST PA SMT 4-Pin to DuPont female single-head wire is offered to facilitate wiring. Length: 210mm, buckle attached.
Product Size
 |
 |
Connection Diagram
 |
Specifications
Sensor
- Operating Voltage: DC 3.3-5V
- Communication Interface: JST PA SMT 4-Pin interface
- Dimensions: 22mm * 29.88mm * 11mm
- Mounting Hole Size: 3mm
- Installation Hole Spacing: 15mm
Wire
- Withstand Voltage: ＜50V
- Withstand Current: ＜1000MA
- Length: 21CM
- Wire Sequence: Black-negative power supply, Red-positive power supply, Green-SDA, Blue-SDA
